Close
Register
Close Window

Show Source |    | About   «  8.5. Selection Sort   ::   Contents   ::   8.7. Optimizing Sort Algorithms with Code Tuning  »

8.6. The Cost of Exchange Sorting

8.6.1. The Cost of Exchange Sorting

Here is a summary for the cost of Insertion Sort, Bubble Sort, and Selection Sort in terms of their required number of comparisons and swaps in the best, average, and worst cases. The running time for each of these sorts is \(\Theta(n^2)\) in the average and worst cases.

\[\begin{split}\begin{array}{rccc} &\textbf{Insertion}&\textbf{Bubble}&\textbf{Selection}\\ \textbf{Comparisons:}\\ \textrm{Best Case}&\Theta(n)&\Theta(n^2)&\Theta(n^2)\\ \textrm{Average Case}&\Theta(n^2)&\Theta(n^2)&\Theta(n^2)\\ \textrm{Worst Case}&\Theta(n^2)&\Theta(n^2)&\Theta(n^2)\\ \\ \textbf{Swaps:}\\ \textrm{Best Case}&0&0&\Theta(n)\\ \textrm{Average Case}&\Theta(n^2)&\Theta(n^2)&\Theta(n)\\ \textrm{Worst Case}&\Theta(n^2)&\Theta(n^2)&\Theta(n)\\ \end{array}\end{split}\]

The remaining sorting algorithms presented in this tutorial are significantly better than these three under typical conditions. But before continuing on, it is instructive to investigate what makes these three sorts so slow. The crucial bottleneck is that only adjacent records are compared. Thus, comparisons and moves (for Insertion and Bubble Sort) are by single steps. Swapping adjacent records is called an exchange. Thus, these sorts are sometimes referred to as an exchange sort. The cost of any exchange sort can be at best the total number of steps that the records in the array must move to reach their “correct” location. Recall that this is at least the number of inversions for the record, where an inversion occurs when a record with key value greater than the current record’s key value appears before it.

8.6.2. Analysis

Settings

Proficient Saving... Error Saving
Server Error
Resubmit

   «  8.5. Selection Sort   ::   Contents   ::   8.7. Optimizing Sort Algorithms with Code Tuning  »

Close Window